Signal SS650 Instruções de Operação descarregar pdf (Página 4)

-3- -8-

INSTALLER-SELECTABLE OPTIONS (cont'inued)

Thunder Disable - The Thunder function can be completely disabled by moving

one of the option jumpers inside the amplifier unit from "Extra" to the "TD". When

Thunder is disabled, the Manual button will not have any effect on the tone while

the siren is in the Yelp mode

Two-Tone Enable - The Two-Tone function can be enabled by moving one of the

option jumpers inside the amplifier unit from "Extra" to the "Two-Tone". When

Two-Tone is enabled, a European Two-Tone sound will replace the Thunder sound

when the Manual button is pressed while the siren is in the Yelp mode. (The tone

will toggle between Yelp and Two-Tone each time the Manual button is pressed)

Auxiliary Horn Polarity - The Auxiliary Input allows activation by an external

source of the Horn function. This input is usually wired into the vehicle horn

switch. The wiring diagram on page 6 shows two connection examples. NOTE:

Permanent disconnection of the vehicle horn is NOT recommended.

The auxiliary input is normally activated by applying a positive voltage to the wire.

To activate by connecting to ground (negative), move the "AUX" option jumper

from the "Pos." pins to the "Neg." pins. (See diagram above).

SIREN OUTPUT:

Selector Switch

Position:

Speaker

Output

Pressing Manual Pushbutton

Wail Wail Yelp

Yelp Yelp Thunder (or Two-Tone)

(Remains Yelp if Thunder disabled)

OFF No Output

Creates a manual WAIL tone while

button is being held that sweeps down

when the button is released.

(NOTE: THUNDER may be optionally disabled via program jumpers. See

INSTALLER-SELECTABLE OPTIONS on pages 2 & 3).

(NOTE: TWO-TONE may be optionally selected over Thunder via program

jumpers. See INSTALLER-SELECTABLE OPTIONS on pages 2 & 3).

AUXILIARY INPUT

During installation an auxiliary input may be connected to the vehicle horn ring or

other switching device. It provides the same operation as pressing the Horn button.

See wiring diagram on page 6 for wiring details.

1 2 3 4 5 6

Sem comentários

Signal SS650 Instruções de Operação Página 4